DoorKing 1816 Owner's Manual download pdf (Page 37)

3.4.4 Programming the User Message – 1837 Systems

The user message is displayed on the top four lines of the 1837 display. This message can be a

maximum of 80 characters (spaces count as a character) and is entered into the system memory in

four blocks. The example below shows how the sample message was divided into four blocks and

centered on the screen. Use the blank matrix to organize your own message. Only upper case

letters, numbers and spaces can be programmed from the system keypad.

Factory Default User Message: This Space is For Your User Programmable Message

NOTE: The factory default message was programmed from a PC, therefore upper and lower case

letters are allowed.

Example

WELCOME TO THE OAKWOOD CONDOMINIUMS PLEASE DRIVE CAREFULLY

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Block 1 W E L C O M E T O T H E

Block 2 O A K W O O D C O N D O M I N I U M S

Block 3 P L E A S E D R I V E

Block 4 C A R E F U L L Y

19 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 20

Block 1

Block 2

Block 3

Block 4

After organizing the user message in the matrix above, follow the instructions below to enter the

message into the system. After each desired letter, number or space is displayed on the directory,

remember to press * to enter that character. Spaces count as a character and must be entered into

memory as a character. After a complete block has been entered, press * to enter the block, then

start the next block.

1. Press *80 and enter the four-digit MASTER CODE _ _ _ _ (beep). The screen will

display: BLOCK 1.

2. Enter the characters into block 1. Remember to press * (beep) after each character.

3. After the last character in block 1 has been entered, press * (beep) to enter the block.

The screen will display: BLOCK 2.

4. Repeat steps 2 and 3 to enter characters into block 2. The screen will display: BLOCK 3.

5. Repeat steps 2 and 3 to enter characters into block 3. The screen will display: BLOCK 4.

6. Repeat steps 2 and 3 to enter characters into block 4.

7. After all four blocks are entered, press * to enter them into the system memory.

8. Press 0# together to end this programming step (beeeeeep).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 64 65

No comments

DoorKing 1816 Owner's Manual Page 37