Owner’s Manual Model 1812 Classic Telephone Intercom Systems DoorKing, Inc.120 Glasgow AvenueInglewood, California 90301 U.S.A. Phone: 310-645-00
Page 10 1812-065-M-3-07 1.1 SURFACE MOUNT UNITS Surface mount units can be mounted directly to a wall or pilaster or post mounted using a DoorKi
Surface Mount Dimensions 1#0*7 8 96543210.0 5.252.8756.1253.05.02.52.5.8751.251.31.875 Dia1812-065-M-3-07 Page 11
Page 12 1812-065-M-3-07 1.2 FLUSH MOUNT UNITS Flush mount units are designed to be mounted directly into a wall or column. Be sure the unit is m
Rough-in Box Dimensions 10.257.54.53.55.0 2.6251.25 Dia Flush Mount Dimensions 1 2 3654987#0*Push ButtonTo Call9.2512.04.253.5.875 Dia7.256.2510.02.55
Page 14 1812-065-M-3-07 1.3 WALL MOUNT UNITS Wall mount units can be mounted directly to a wall or pilaster or post mounted using a DoorKing moun
Wall Mount Dimensions 1 2 3654987#0*7.32510.75 3.51812-065-M-3-07 Page 15
1.4 BY-PASS SWITCH INSTALLATION AND WIRING • The by-pass switch should be installed in a location where it is accessible by the homeowner. • The by
1.5 TELEPHONE LINE WIRING – SINGLE UNIT If any alarm systems are installed on the phone line, be sure that the alarm interface precedes the 1812 by-
1.6 TELEPHONE LINE WIRING – MULTIPLE UNITS If any alarm systems are installed on the phone line, be sure that the alarm interface precedes the 1812
1.7 INTERCOM MODE WIRING – SINGLE UNIT Use this wiring diagram when a single 1812 is programmed for intercom mode and is connected directly to anoth
Page 2 1812-065-M-3-07
1.8 INTERCOM MODE WIRING – MULTIPLE UNITS Use this wire diagram when multiple 1812 units will be connected together in an intercom mode and connecte
1.9 MAIN TERMINAL DESCRIPTION 1 - Phone In2 - Phone In3 - Case Ground4 - Phone Out5 - Phone Out6 - Time Zone Clock Input7 - Input 1 (Activates Relay
1.10 PANEL TERMINAL DESCRIPTION 17865432REDWHITEGREENFront Panel TerminalSpeakerPushButtonMicBoardLight • If the 1812 is to be powered from a 24-Vo
SECTION 2 – PROGRAMMING The DoorKing 1812 Telephone Intercom System can be programmed by three different programming methods. • KEYPAD: The keypad
Page 24 1812-065-M-3-07 2.2 PC PROGRAMMING SET-UP Prior to programming the 1812 with the DoorKing Auto-Programming Software for Windows, the sys
2.3 GENERAL PROGRAMMING Proceed with the programming steps on the following pages if PC programming will not be used. 2.3.1 Relay Strike Time The
Page 26 1812-065-M-3-07 2.3.3 Phone / Intercom Mode The 1812 is normally connected in series with a residents incoming phone line, which supplies
2.3.6 Number of Rings This programming section sets the number of rings that the 1812 will allow to pass through the system before it picks up the ca
2.4 TIME FUNCTION PROGRAMMING 2.4.1 Time Clock Programming This programming sequence programs the calendar chip in the 1812 system for the current t
2.4.3 Automatic Relay Activation Time Zones This program sequence sets up time zones to automatically activate and deactivate the relays on the contr
Use this manual with the following models only. All 1812 Telephone Intercom Systems with circuit board 1871-010 REV S or higher. DoorKing, Inc. rese
Page 30 1812-065-M-3-07 2.4.5 Call Forward Time Zone This programming sequence sets up a time zone for the call-forwarding feature. The 1812 will
2.5 PROGRAMMING DIAL-OUT FUNCTIONS 2.5.1 Call Forward Programming These steps program the call forwarding telephone number into the 1812 memory. Ca
Page 32 1812-065-M-3-07 2.6.1 Four-Digit Entry Code Programming This programming sequence programs four digit entry codes into the system memory
SECTION 3 – ADJUSTMENTS Speaker Volume The speaker volume potentiometer is labeled SPEAKER VOL on the control board. The speaker volume should be adj
Circuit Board Adjustment Locations PH InPH OutMstrCodeKeypadSpkr Vol123456789101112131415161718FB 1FB 21 2 3 4 5 6 7 8 Page 34 1812-065-M-3
SECTION 4 – OPERATING INSTRUCTIONS 4.1 Calling the Resident To place a call from the 1812 to the resident’s house, the guest simply presses the PUSH
Page 36 1812-065-M-3-07 4.3 Preprogrammed Numbers To use the preprogrammed phone number feature, the guest simply presses 01, 02, or 03 on the sys
Resident Operating Instructions The following operating instructions assume that the 1812 features are being turned on and off from the resident’s tou
Page 38 1812-065-M-3-07 4.8 Entry Code Time Zone Enable / Disable The entry code time zone affects only those entry codes programmed under the ti
4.11 Relay Activation Check The 1812 can be called to check if relay 1, relay 2, or both relays in the system are latched and holding a door or gate
TABLE OF CONTENTS Preface Important Notices...
Page 40 1812-065-M-3-07 4.14 Switch Input Operation A switch closure between terminals 7 and 9 will activate relay 1 for its programmed strike ti
SECTION 5 – MAINTENANCE The DoorKing telephone entry system is essentially a maintenance free device. When the unit is properly installed, it should
Page 42 1812-065-M-3-07 Isolating Noise Problems 1. Remove all external items connected to the 1812 unit, such as back-up batteries, relay connec
SYMPTON POSSIBLE SOLUTION(S) Cannot get into programming mode. • Wrong master code entered. Start over. • Waiting too long between pushing buttons.
SYMPTON POSSIBLE SOLUTION(S) System generates tone when granting access to a visitor, but will not work on regular phone line. • Switch the wires on
5.2 ACCESSORIES Slave Keypad Allows remote activation of the system relays by use of the entry codes. Does not provide any voice communication to
Page 46 1812-065-M-3-07 Complete the information in the tables on the following pages to maintain a record of the information that has been progr
Entry Code Log Sheet Location Number Relay Function Entry Code Location Number Relay Function Entry Code 01 1 Momentary 26 2 Momentary 02 1 Mom
Section 3 – Adjustments Speaker Volume...
IMPORTANT NOTICE FCC - UNITED STATES This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Par
IMPORTANT INFORMATION • Prior to beginning the installation of the telephone entry system, we suggest that you become familiar with the instructions
FEATURES • Unique telephone communication system allows homeowners to use their telephone as an intercom to speak to a guest at a front door or gate
SECTION 1 - INSTALLATION • Installation of the telephone intercom system involves the installation and wiring of the Entry System By-pass Switch and
Comments to this Manuals