Doorking 6500 User Manual download pdf (Page 24)

6500-065-K-7-08

3.1 Circuit Board Adjustments

SECTION 3 - ADJUSTMENTS

The switch settings and adjustments in this chapter should be made after your installation and wiring to the operator(s) is

complete. Whenever any of the programming switches on the circuit board are changed, power must be shut-off, and then

turned back on for the new setting to take effect.

• Auto close timer

(when turned on)

SW 1, switch 4.

Adjust from 1

second (full

counter clockwise)

to approximately

23 seconds (full

clockwise).

• Dry relay contacts

(terminals 10-11) can be

set for Normally Open

(NO) or Normally Closed

(NC) operation by placing

the relay shorting bar on

the N.O. or N.C. pins

respectively.

Self test mode is for

bench checks only.

The operator will

continually cycle the

gate.

The jumper must be

set at normal mode

to function.

• Set the DIP-switches on the

circuit board to the desired

setting. See switch-setting

charts on next page.

2 3 4 5 6 7 8

N.C.

N.O.

SW 1

Self Test

Mode

Normal

Mode

2 3 4

SW 2

Loop Detector

123

9410

EXITSHADOW SHADOW OUTPUTREVERSE

9409

Self Test

Auto Close TimerDIP-Switches

Dry Relay Contact

• Adjust reversing sensitivity

for PRIMARY (single) and

SECONDARY (dual) operators.

Min Max

Secondary Primary

Min Max

Reverse Sensor

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Comments to this Manuals

No comments

Doorking 6500 User Manual Page 24

Comments to this Manuals