DoorKing 1816 Owner's Manual download pdf (Page 27)

SECTION 3 – PROGRAMMING

IMPORTANT! Many of the advanced features available with this telephone entry system cannot be

programmed from the system keypad. These features include relay hold open time zones, security

levels, and elevator control options. If any of these features are used, the system must be

programmed with the DoorKing Remote Account Manager for Windows software, VERSION 5.4.

Refer to the software User's Manual for more information on these features.

We strongly suggest that you read these programming instructions in their entirety before beginning

any programming of this telephone entry system.

3.1 General Programming Information

The DoorKing PC Programmable Telephone Entry System is primarily programmed by using the

DoorKing Remote Account Manager for Windows software and the user supplied PC by either RS-

232 connection or by modem, however it can also be programmed from the keypad on the front of the

entry system. When programming from an off site location with a PC, the RING pin must be installed

on the circuit board.

The PC programmable telephone entry systems (except 1834) have three relays on the circuit board,

all of which are programmable for any function required. These relays are designated as Relay 0 (R-

0), Relay 1 (R-1), and Relay 2 (R-2). If Tracker expansion boards are used with this system, it is very

important that you understand the function of these three relays. The weigand input auxiliary

terminals (also the Tracker board input terminals) can only cause R-1 or R-2 to activate. Weigand

input devices cannot cause R-0 to activate. Therefore, if Tracker expansion boards are used with this

system, R-0 must be designated as the PRIMARY relay, and R-1 and R-2 are then designated as

Tracker board command (CMD) relays with R-2 controlling tracker boards 1 through 8 (system relays

3-10), and R-1 controlling tracker boards 9 through 16 (system relays 11-18). The PRIMARY relay is

the relay that a resident activates from their telephone after receiving a call from a visitor. When

tracker boards or other weigand devices are used with the system, be sure that R-0 is programmed to

respond to the tone open number (typically 9), the postal switch input, and the rotary dial 9 function.

Refer to the Remote Account Manager User's Manual for more information on Tracker board relay

numbering scheme and designations.

The Anti-Pass Back feature requires the use of APB chips installed in the telephone entry system.

Anti-Pass Back will not function with a standard chip set.

Device codes, tracker expansion, anti-pass back and elevator control features are NOT AVAIALBLE

with the 1834 system.

3.1.1 Programming with a PC

Prior to programming the system with a personal computer and the DoorKing Remote Account

Manager for Windows software, there is certain information that you must know and must program

into the system before the computer can communicate with the system. See page 29 to set-up the

telephone entry system for PC programming. Programming the system with a PC may be

accomplished either by modem or by direct connection using the RS-232 communications terminal on

the circuit board. Using the RS-232 communications terminal will require the use of a cable with a

DB-9 connector on one end (DoorKing P/N 1818-040), and the DoorKing Remote Account Manager

for Windows software VERSION 5.4.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 64 65

No comments

DoorKing 1816 Owner's Manual Page 27