DoorKing 1812 Owner's Manual download pdf (Page 29)

2.4.3 Automatic Relay Activation Time Zones

This program sequence sets up time zones to automatically activate and deactivate the relays on the

control board. Each relay can be programmed with two independent time zones. Time zones 1 and 2

affect relay 1 operation; time zones 3 and 4 affect relay 2 operation. These time zones can be

independently turned on or off after they have programmed.

1. Press * 3 5 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the time zone number _ then press * (beep).

3. Press 0 * (beep) to turn time zone off, or press 1 * (beep) to turn time zone on.

4. Enter the begin time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press

1 * (beep) for PM.

5. Enter the end time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press

1 * (beep) for PM.

6. Enter the days of the week that the time zone is to be active _ _ _ _ _ _ _ then press

* (beep). NOTE: Sunday = 1, Saturday = 7. To skip a day (or days) of the week,

enter # in place of the day. For example, if the time zone is to be active Saturday and

Sunday only, enter 1 7 # # # # # in step 6.

7. Repeat steps 3 through 7 to program the other time zones.

8. Press 0# TOGETHER to end this programming step (beeeeeep).

2.4.4 Entry Code Time Zones

This programming sequence sets up a time zone for all four-digit entry codes that have been

programmed into the time zoned entry code location areas. Entry codes that are programmed into

these location areas will not work outside of the programmed time zone. This time zone can be turned

on or off once it is programmed. See 2.6.1 to program entry codes.

1. Press * 3 6 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Press 0 * (beep) to turn time zone off, or press 1 * (beep) to turn time zone on.

3. Enter the begin time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press

1 * (beep) for PM.

4. Enter the end time hour and minutes _ _ _ _ then press 0 * (beep) for AM, or press

1 * (beep) for PM.

5. Enter the days of the week that the time zone is to be active _ _ _ _ _ _ _ then press

* (beep). NOTE: Sunday = 1, Saturday = 7. To skip a day (or days) of the week, enter

# in place of the day. For example, if the entry code time zone is to be active Monday

through Friday only, enter 2 3 4 5 6 # # in step 5.

6. Press 0# TOGETHER to end this programming step (beeeeeep).

1812-065-M-3-07 Page 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 46 47

No comments

DoorKing 1812 Owner's Manual Page 29