DoorKing 1812 Owner's Manual download pdf (Page 30)

2.4 Devices

2.4.1 Simple Access Code Programming

This programming sequence programs simple access codes into the system memory. Simple access

codes cannot be time zone restricted; they can only be assigned to operate either relay 1 or relay 2

on a 24/7 basis. If you require access codes to be time zone restricted, use the programming

sequence in 2.4.2.

Note: Up to 50 access codes can be programmed into the system. This 50 includes access codes

programmed in 2.4.1 AND 2.4.2. For example, if 10 access codes are programmed in 2.4.1, then

only 40 can be programmed in 2.4.2

1. Press * 0 2 and enter the MASTER CODE. [ * 0 2 _ _ _ _ (beep)]

2. Press 1 for relay 1 OR Press 2 for relay 2, then press *. [ _ * (beep)]

3. Enter a five-digit access code then press *. [ _ _ _ _ _ * (beep)]

4. Repeat steps 2 and 3 to enter additional codes.

5. Press 0# TOGETHER to end. [0# (beeeeeep)]

2.4.2 Access Code Programming

This programming sequence programs access codes into the system memory with time zone

restrictions applied. It also allows programming of the access codes to momentarily activate a relay

or to hold (latch) a relay.

1. Press * 7 0 and enter the MASTER CODE. [ * 7 0 _ _ _ _ (beep)]

2. Press 2 *. [ 2 * (beep)]

3. Enter a five-digit access code then press *. [ _ _ _ _ _ * (beep)]

4. Enter a minimum of 1, and a maximum of 4 time zones (valid time zones are 0 through 6)

that you want to apply to this access code, then press *. [ _ _ _ _ * (beep)]

Time zone 0 is always deny access, time zone 1 allows 24/7 access for relay 1only; time

zone 2 allows 24/7 access for relay 2 only. Time zones 3, 4, 5 and 6 are time zones that

have been programmed in 2.5.6.

5. Enter 0 * for momentary relay activation or enter 1 * to hold (latch) the relay. [ _ * (beep)]

6. Repeat steps 2 through 5 to program additional access codes.

7. Press 0# TOGETHER to end. [0# (beeeeeep)]

2.4.3 Delete Access Codes

This programming sequence deletes access codes that have been programmed into the system.

1. Press * 7 1 and enter the MASTER CODE. [ * 7 1 _ _ _ _ (beep)]

2. Press 2 *. [ 2 * (beep)]

3. Enter the five-digit access code to be deleted then press *. [ _ _ _ _ _ * (beep)]

4. Repeat steps 2 and 3 to delete additional access code numbers.

5. Press 0# TOGETHER to end. [0# (beeeeeep)]

Page 30 1812-161-E-1-10

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 52 53

No comments

DoorKing 1812 Owner's Manual Page 30