Doorking 1802 Entry System User Manual download pdf (Page 25)

3.1.5 Talk Time

This programming sequence sets the maximum time allowed for conversation when the entry system

places a call to the resident. The talk time can be set from 1 second up to 255 seconds (4 minutes,

15 seconds) and is entered as a three-digit number. For example, to set a talk time of 20 seconds,

enter 020 in step 3. The talk time set here does not affect the telephone numbers that are

programmed under directory codes 0, 00, 000, 0000 and 1, 01, 001, 0001. The talk time for these

two directory codes are factory set to the maximum. Phone numbers programmed under these

directory codes should be reserved for management or emergency phone numbers that generally

require longer conversations.

Factory setting for talk time = 060 (60-sec).

1. Press *08 and enter the four digit MASTER CODE _ _ _ _ (beep).

2. Enter three digits for talk time (seconds) _ _ _ (001-255) then press * (beep).

3. Press 0# TOGETHER to end this programming step (beeeeeep).

3.1.6 Tone Open Numbers

These steps will program the tone open numbers for relays 1 and 2. You will need to enter a four-

digit number (see chart below) to set the relay functions. If a function is not desired, enter # in place

of a number. For example, if you want the relay to have a momentary activation function only, and

you want the relay to activate when the number 9 is pressed, enter 9 # # # in step 3. Do not duplicate

tone open numbers, i.e., don’t set relay 1, and 2 tone-open numbers to 9.

Factory setting is: Relay 1 = 9876, Relay 2 = 5432.

1. Press *05 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Press 1* to set relay 1 or 2* to set relay 2 tone numbers.

3. Enter the four-digit tone open number code _ _ _ _ then press * (beep).

4. Repeat steps 2 and 3 to set the other relay tone open numbers.

5. Press 0# TOGETHER to end this programming step (beeeeeep).

CODE (step 3) FUNCTION

Digit Momentary activation. Relay will activate for the programmed strike time (3.1.3).

Digit Relay hold. Relay will activate and remain activated until commanded to release.

Digit Relay release. Deactivates the relay hold command.

Digit Relay hold 1-hour. Relay will activate for 1-hour and then will automatically deactivate itself.

3.1.7 Touch-tone / Rotary-dial

This programming sequence will set the telephone entry system to dial out in either a touch-tone or

rotary format. Generally, this will be set for touch-tone.

Factory setting = 0 (touch-tone).

1. Press *07 and enter the four digit MASTER CODE _ _ _ _ (beep).

2. Enter 0* (beep) for touch-tone or enter 1* (beep) for rotary.

3. Press 0# TOGETHER to end this programming step (beeeeeep).

1802-065-E-5-10 Page 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 52 53

No comments

Doorking 1802 Entry System User Manual Page 25