DoorKing 1812 Owner's Manual download pdf (Page 19)

1.7 INTERCOM MODE WIRING – SINGLE UNIT

Use this wiring diagram when a single 1812 is programmed for intercom mode and is connected

directly to another telephone or to an un-used C.O. port on a PBX or KSU type system.

Phone In - 1

Phone In - 2

Case Ground - 3

Phone Out - 4

Phone Out - 5

1812

Main

Terminal

Programmed for

INTERCOM MODE

1. When the 1812 is programmed for intercom mode, it provides the constant source of DC

voltage necessary for communication. The intercom mode also disconnects the phone in

terminals (1 and 2) since they are not used.

2. Be sure that the 1812 is programmed in the intercom mode when connecting the unit as

shown above.

3. Use only twisted pair telephone wire that has proper insulation for direct underground

burial. Do not use thinly insulated wire, even if the phone lines will be run in a conduit. Do

not make any splices to the phone lines. If splices are made, they must be soldered and

insulated in a watertight enclosure.

4. Surge protection is recommended on the phone out lines. Use DoorKing phone line surge

suppresser (p/n 1877-010) or equivalent.

1812-065-M-3-07 Page 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 46 47

No comments

DoorKing 1812 Owner's Manual Page 19