Doorking 1812 Plus User Manual download pdf (Page 21)

SECTION 2 – PROGRAMMING

Before You Start

The 1812 has been programmed at the factory with many of the programming parameters already set

(default setting) for a typical residential application with a single 1812. There is no need to reprogram

these parameters unless you want to change them. For easy reference, refer to the chart on the next

page that list the various programming functions and their default settings.

Important! You MUST program a Master Code before any of the programming steps in Section 2

can be started. Be sure to write down the Master Code that you programmed as it will be required for

all programming steps in this Section.

Programming the Master Code

This programming step sets the system MASTER CODE. The master code is the four-digit number

required to gain access to the system memory. The master code can only be programmed from

the system keypad.

Default setting is NONE. You MUST program a Master Code.

1. Open the cabinet of the telephone entry system and press the master code button. The

Blinking LED next to the button will turn ON.

Note: After you press the master code push button, the LED will turn ON indicating that

you are in the master code programming sequence. If a master code is not entered

within 10 seconds, the master code program sequence will automatically end and the

LED will return to a blinking state indicating that you have exited the master code

programming sequence.

2. Enter a four-digit master code then press *. [ _ _ _ _ * (beep)] (The LED will revert to

Blinking).

3. Close the cabinet.

Mic

Vol

1234567891011

Speaker

Vol

Keypad

Master Code

Push Button

Master Code

LED

1812-161-E-1-10 Page 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 52 53

No comments

Doorking 1812 Plus User Manual Page 21